Alphatek

Linear Shower Drain Size Guide

Find the right linear shower drain length for your shower and the floor fall you need – free, in seconds.

Linear shower drain size guide

Enter your shower size to find the right standard drain length and the floor fall.

Suggested drain

Standard lengths: 300, 450, 600, 900 and 1200 mm.

0mm long
  • Width and outlet80 mm / 50 mm outlet
  • Tiled gap at each end–
  • Floor fall to the drain–
  • Material304/316 stainless steel

A rough guide. Check the floor build-up, the waterproofing and the outlet position on site. Send us your shower plan and we will confirm the drain.

Get a shower drain quotation

How the guide works

Our linear shower drains come in standard lengths of 300, 450, 600, 900 and 1200 mm, all 80 mm wide with a 50 mm outlet. The guide picks the longest standard drain that fits the width of your shower with room for tiles at each end, then works out how much the floor must fall from the far side of the shower to the drain.

Where to place the drain

  • Against the wall: the most popular choice. The floor slopes in one direction, so large tiles can be laid with few cuts.
  • Across the entrance: keeps water inside a level-access shower.
  • In the middle: the floor slopes to the drain from both sides, as with a point drain.

Floor fall

Shower floors usually fall 1–2% towards the drain, which is 10–20 mm for every metre. Too little fall leaves puddles; too much feels uneven underfoot. Plan the fall in the screed under the waterproofing.

See our floor drains and linear shower drains, the 600 mm linear shower drain and our linear shower drain design tips.

Frequently asked questions

What lengths of linear shower drain are available?
Our standard lengths are 300, 450, 600, 900 and 1200 mm. All are 80 mm wide with a 50 mm outlet.
How long should a linear shower drain be?
Choose the longest standard length that fits the shower width with a small tiled gap at each end. For a 900 mm wide shower, a 600 mm drain is a good fit when placed against the wall.
How much fall does a shower floor need?
Usually 1–2% towards the drain, which is 10–20 mm for every metre of floor.
Should the drain go against the wall or in the middle?
Against the wall is the most popular choice, because the floor slopes one way and large tiles need fewer cuts.
What is a tile-insert linear drain?
A drain with a tray on top that is filled with the same tile as the floor, so only two thin lines show.

Need Shower Drains for Your Project?

Alphatek – Delivering drainage solutions that keep your projects flowing.

Scroll to Top
Hi! 👋 Need a product or a quotation? Ask me.