Alphatek

How to Install a Linear Shower Drain: Falls, Waterproofing and Tiling

Looking for a supplier? Alphatek is a linear shower drain supplier in Dubai and the UAE: stainless steel 304/316 channels with slotted, square-pattern and tile-insert grates.

Linear shower drains make level-access and walk-in showers possible, because the floor only has to fall in one direction. They are also less forgiving than a point drain: the channel must be level along its length, the falls must be even and the waterproofing must be bonded all round.

Tile-insert linear drain detail in a walk-in shower

Choose the length and position

  • Against the wall: the most common layout. The floor falls one way, towards the wall, and the channel runs full width
  • At the shower entrance: keeps water inside the shower zone in level-access bathrooms
  • Length: wall to wall gives the cleanest look; otherwise leave equal gaps at both ends

Use our linear shower drain size guide to pick the length and outlet size.

Installation steps

1. Set the channel level

Fix the channel on its adjustable feet so it is level along its length and at the right height for the finished tiles. A channel that is not level holds water at one end.

2. Connect the outlet

Connect the outlet and trap to the waste pipe and check for leaks before anything is covered.

3. Screed to a single fall

Lay the screed so the whole shower area falls towards the channel in one plane. This lets you use large tiles with very few cuts.

4. Bond the waterproofing

Lap the membrane onto the channel flange, or use the sealing tape supplied with the system, and seal the corners. Take the membrane up the walls as the specification requires.

5. Flood test

Flood the shower area and check below before tiling.

6. Tile and fit the grate

Tile up to the channel edge. For a tile-insert grate, bond a strip of the floor tile into the grate tray so the drain almost disappears.

Linear shower drain in an apartment bathroom in Sharjah

Which grate to choose

GrateBest for
SlottedSimple, modern look; easy to clean
Square patternHotels and apartments, with good grip underfoot
Tile insertMinimal designs where the drain should blend into the floor

For more design ideas, read linear shower drain design tips.

Frequently asked questions

Does a linear shower drain need a slope?

The floor needs a fall towards the drain, but only in one direction. The channel itself is installed level.

Where should a linear shower drain go?

Most are placed along the back wall of the shower. In level-access bathrooms, a drain at the shower entrance keeps water from spreading into the room.

What length of linear drain do I need?

Wall to wall gives the cleanest finish. Otherwise choose a length close to the shower width, with equal gaps at each end.

Can I use a linear drain on a balcony or terrace?

Yes, choose stainless steel 316 for outdoor and coastal areas, and check the outlet size against the area that drains to it.

How do I clean a linear shower drain?

Lift the grate, remove the hair trap, rinse it and wipe the channel. Clean it every few weeks in a busy bathroom.

Need linear shower drains?

Send us the shower size, grate style and quantity, and we will quote stainless steel linear drains for projects across Dubai and the UAE. See also the 600 mm SS 316 linear shower drain. Request a quote or email sales@alphatek.ae.

Scroll to Top
Hi! 👋 Need a product or a quotation? Ask me.