Looking for a supplier? Alphatek supplies gully traps, sand traps and PVC floor traps in Dubai and across the UAE.
Gully traps and floor traps are often mixed up on site, in BOQs and even on drawings. Both stop drain smells coming back into a space, and both sit at the low point where water collects. But they do different jobs, sit in different places and take different loads. Ordering the wrong one usually means a smelly room, a blocked outlet or a broken grating.
This guide explains the difference in plain terms, so you can check a schedule or drawing before you order.

What is a floor trap?
A floor trap is a small trap set into the floor slab of a room, such as a bathroom, kitchen, laundry, balcony or plant room. Water from the floor and from appliances runs through a grate into the trap. A water seal inside the trap stops sewer gas rising back into the room.
Floor traps are usually PVC or uPVC bodies with a stainless steel or plastic grate on top, or all-stainless bodies for wet, hot or hygienic areas. They are sized for the water from one room, not for a whole roof or yard. See our guide to PVC vs stainless steel floor traps for help choosing the material.
What is a gully trap?
A gully trap (or gully) is a larger trap that collects water at ground level, usually outside or in service areas: yards, car parks, ramps, wash-down areas, refuse rooms and the foot of rainwater pipes. It also has a water seal, but its body is bigger and deeper so it can take more water and hold back sand and silt before they reach the drain line.
Gullies usually have a heavier grating on top, sized for the area around them: a light grating for a garden or service yard, a heavy-duty grating where vehicles pass.
Gully trap vs floor trap at a glance
| Floor trap | Gully trap | |
|---|---|---|
| Where | Inside rooms: bathrooms, kitchens, balconies, plant rooms | Outside and service areas: yards, car parks, ramps, bin rooms, rainwater pipe outlets |
| Water collected | Floor wash water and appliance discharge from one room | Surface water, wash-down water and rainwater from a larger area |
| Size | Small, shallow body to fit within the slab and screed | Larger, deeper body, often 200 mm diameter or more |
| Sand and silt | Little or none | Often needs a sand or silt bucket that can be lifted out and emptied |
| Top | Tile-level grate, often stainless steel | Grating sized for foot or vehicle traffic |
| Typical material | PVC/uPVC body, stainless steel 304/316 grate or body | PVC, GRP or stainless steel body with matching grating |
When you need a gully trap
- Car parks, ramps and loading areas, where water carries sand and oil residue
- Service yards, refuse rooms and wash-down areas
- At the foot of rainwater downpipes, before water enters the underground drain
- Anywhere sand and dust are blown in, which is most open areas in the UAE
For these areas a gully with a removable silt bucket saves a lot of drain jetting later. Alphatek supplies PVC gully traps, gratings and sand/silt trap buckets, plus GRP gully traps with sediment buckets for heavier or corrosive areas.
When you need a floor trap
- Bathrooms, toilets and showers without a linear drain
- Kitchens, laundries and utility rooms
- Balconies and terraces with a tiled finish
- Plant rooms and AC rooms, where equipment drains to the floor
Here the trap must sit within the slab depth and the grate must finish flush with the tiles. Alphatek supplies PVC floor traps and stainless steel gullies and floor traps in SS 304/316.
Common mistakes to avoid
- Using a floor trap outside. It fills with sand quickly and its small grate cannot take the water from a large paved area.
- Using a light grating where vehicles drive. Match the grating to the traffic: light-duty for foot traffic, heavy-duty for cars and trucks. See light-duty vs heavy-duty gratings.
- Letting the water seal dry out. Traps in rooms that are rarely used lose their seal and let smells in. Pour water in regularly or choose a trap with an anti-evaporation feature.
- Skipping the silt bucket. In sandy areas a gully without a bucket sends sand straight into the drain line.
How a gully trap works
A gully trap is a fitting with a U-shaped bend that always holds some water, called the water seal. Surface and waste water enter through the grating at the top, pass through the bend and flow out to the drain. The water left in the bend blocks drain gases, so smells cannot come back up through the grating.
Many gully traps also have a removable sediment bucket under the grating. Sand, leaves and grit settle in the bucket instead of the pipe, and the bucket is lifted out and emptied during cleaning. See gully traps and sand traps and GRP gully traps with sediment buckets.
Frequently asked questions
Is a gully trap the same as a floor trap?
No. Both have a water seal that keeps drain smells out, but a floor trap is a small trap inside a room, while a gully trap is a larger trap that collects surface water outside or in service areas and often holds back sand and silt.
Where should a gully trap be used?
Use gully traps in car parks, ramps, service yards, refuse rooms, wash-down areas and at the foot of rainwater downpipes, where a lot of water and sand reach the drain.
What size is a standard gully trap?
PVC gully traps are commonly 200 mm in diameter with a 300 x 300 mm grating, but the size should follow the drainage drawing and the area being drained.
Why does my floor trap smell?
Usually because the water seal has dried out in a room that is not used often, or because the trap is blocked. Refill the trap with water and clean it. Our guide to floor drain smells covers the other causes.
Do gully traps need a sand bucket?
In the UAE it is strongly recommended for outdoor and car park gullies. A removable sand or silt bucket catches sand before it reaches the drain line and can be lifted out and emptied during maintenance.
How does a gully trap stop smells?
Its U-bend always holds water, and that water seal blocks drain gases from coming back up through the grating. If the gully is rarely used, top it up with water so the seal does not dry out.
Can a gully trap take waste pipes as well as rainwater?
Yes. Many gully traps have side inlets for waste pipes as well as the grating on top for surface water. Check the inlets on your drawing.
Need gully traps or floor traps for your project?
Send us your drawing or BOQ with the sizes, locations and quantities, and we will reply with options and a price. We supply across Dubai, Abu Dhabi, Sharjah and the rest of the UAE. Request a quote, call or WhatsApp Justin Varghese on +971 54 466 7243, or email sales@alphatek.ae.
More in Floor Traps, Gullies & Cleanouts
Drainage Accessories · Sediment Interceptors in Dubai & the UAE · Floor Cleanouts · Stainless Steel Floor Cleanout · Floor Cleanout Covers: Screw-Down or Recessed Tile-In?